No deformation of non-hardening acrylics
13 april 2012 - BUSCH & CO introduceert vandaag haar nieuwe product. Hieronder treft u de originele tekst aan.
Non-hardening acrylics are difficult to work with using carbide cutters with conventional cuts. A great deal of pressure is often required due to the relatively blunt cutting angle, thus causing deformation of the material.
BUSCH has developed carbide cutters with GQSR-cut for this purpose. This special coarse, straight-cut with enhanced cross-cut and sharp cutting edges makes it easier to work with non-hardening acrylics and is very gentle on the material.

These carbide cutters made out of finest grain carbide are available in four different shapes for a variety of applications.
Additional information is available upon request from the manufacturer.
Kunt u niet vinden wat u zoekt? Gebruik de zoekmachine.
oktober 2026
In dit nummer onder meer aandacht voor Smile design met Erik Mentink (Oral Design Erik Mentink), Veneers - minimale invasieve therapie voor een maximaal esthetisch resultaat, Andréj Lazi over de onzichtbare achtergrond van de morfologie van posterieure gebitselementen, Kunstharsmaterialen voor het 3D-printen en frezen van indirecte restauraties: samenstelling en uitloogbare stoffen onderzocht met een kunstmatig-speekselmodel, de ATT Verzekerings- en Vergoedingenwijzer Tandtechniek 2027, het Mijnmond.info-Vacature-overzicht, de Dentale Agenda en het Kwaliteitsregister Tandtechniek en meer.
Verspreiding in oktober 2026.
Heeft u nieuws voor het volgende nummer of een interessante casus? Neem dan contact op met de redactie.